User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 304
Dialogic Corporation
Resolved IPY00016070 29869 -- DM3 Network After re-download of remote side, the local Layer2 still
thinks that Layer1 is down and does not issue SABME
request.
Resolved IPY00010627 35339 74 DM3 Network Using Dialogic
®
DMV1200B Boards with NFAS group
of 5 spans, you cannot make calls from the 5th span
when the NFAS group is on two boards.
Resolved IPY00010593 35619 74 DM3 Network Using the default pdk_us_ls_fxs_io.cdp file, the
application is not able to detect the DISCONNECT
tone that is defined in the .cdp file.
Resolved IPY00009790 34269 56 DM3 Network The gc_AlarmSourceObjectNameToID( ) function
doesn’t return pass or fail when used with Dialogic
®
DM3 Boards; it throws an exception that the
application either catches, or, if not programmed to
catch, an application error is generated.
Resolved IPY00009660 35169 74 DM3 Network On Dialogic
®
DM/V-A and DM/V-B Boards with
pdk_us_ls_fxs protocol and
CDP_WaitDialToneEnabled =1, when blind transfer is
initiated but no dial tone is available on the line, the
gc_BlindTransfer( ) function does not return and the
channel hangs.
Resolved IPY00009494 33772 30 DM3 Network Outbound calls fail with “Out Of Order” error on
Dialogic
®
DM3 Fax Board running GDK load.
Resolved IPY00009300 34862 56 DM3 Network With NET5 protocol, firmware does not send
GCEV_PROGRESSING event to application upon
reception of a PROGRESS message with unknown
but syntactically correct event. Unless the message is
incorrectly formatted, the event should always be
generated.
Resolved IPY00008659 32773 18 DM3 Network The gc_SetInfoElem( ) function does not allow you to
set MLPP IE (0x41) nor does it allow CodeSet shift 5
(0x95) when using 5ESS or 4ESS on Dialogic
®
DM3
Boards.
Resolved IPY00008391 31850 18 DM3 Network The Connected Number Information Element is
ignored in CALL CONNECT ISDN message.
Resolved IPY00007916 32554 18 DM3 Network When a span is set as NET5 network end and an
incoming SETUP message comes in without a
channel ID IE, the SETUP is ignored.
Resolved IPY00007844 27539 22 DM3 Network If a call is received on Q.931 where there is no
channel ID in the SETUP message, the call is rejected
by the firmware.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description