User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 310
Dialogic Corporation
Resolved IPY00016066 29040 -- Global Call GCEV_OFFERED event received on a board device
(DTIB1) causes application to crash when using
overlap receive.
Resolved IPY00015514 30170 -- Global Call A NON RECOVERABLE FATAL ERROR occurs if a
call is dropped at the remote-end in the ACCEPTED
state. After that, the port is dead and there is no way to
feasibly recover.
Resolved IPY00010364 35130 56 Global Call The GCEV_DIALING event is being reported too early
when using PDK CAS/R2 protocol on Dialogic
®
DM3
Boards.
Resolved IPY00010129 34274 56 Global Call Dialogic
®
Global Call Software does not provide a way
to disable DISCONNECT TONE SUPERVISION with
pdk_na_an_io.cdp.
Resolved IPY00010035 35159 56 Global Call Under certain conditions when a gc_MakeCall( )
attempt times out, it incorrectly displays the result
message as NORMAL CLEARING instead of timeout.
Resolved IPY00009673 33519 18 Global Call After many successful outbound calls, a
gc_MakeCall( ) fails with GCEV_DISCONNECTED
(gc_msg=Event caused by protocol error,
cc_msg=Pcikup). After that, all subsequent calls on
that network device fail with the same reason. The
problem gets cleared only after the device is closed
and reopened.
Resolved IPY00009517 33543 18 Global Call GCAMS incorrectly reports the DCHAN_CFA alarm as
a DTE1_LOS alarm when the D-channel is down.
Resolved IPY00009462 34121 39 Global Call GCEV_FATAL_ERROR events occur frequently when
using R2 PDK protocols, and channels can be lost
until the boards are redownloaded.
Resolved IPY00009457 32846 18 Global Call The gc_DropCall( ) function fails to send a completion
event when an alarm occurs right after the function is
issued.
Resolved IPY00009131 32810 18 Global Call Running a Dialogic
®
Global Call program with both
analog and digital line devices enabled will cause an
error if the program also opens a digital board device.
The following error message is generated: Insufficient
number of functbls.
Resolved IPY00009094 33816 56 Global Call When disconnecting and reconnecting spans running
the pdk_mx_r2_io protocol, GCEV_FATAL_ERROR
events occur.
Resolved IPY00009024 32014 18 Global Call When performing call progress using the
gc_MakeCall( ) function on Dialogic
®
DM3 Boards,
the TSP does not distinguish between the
CaNoRingback and CaNoAnswer responses.
Resolved IPY00008293 35190 56 Global Call When gc_MakeCall( ) is issued under PDK CAS, with
CPA parameters specified (GC_PARM_BLK), an
access violation occurs.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description