User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 311
Dialogic Corporation
Resolved IPY00008150 33069 18 Global Call gc_MakeCall( ) changes the CRN value after the
permanent signal timer expires.
Resolved IPY00007743 30029 -- Global Call Sometimes the first gc_MakeCall( ) under T1 ISDN
with R4 will not complete successfully.
Resolved IPY00006856 36800 98 Global Call When a board device is closed while time slots are still
open on that trunk, the board device fails to open
when the application tries to open the board again.
The gc_OpenEx( ) to reopen the span fails with an
Invalid linedevice error.
Resolved IPY00006790 35137 131 Global Call For outbound Dialogic
®
Global Call SS7 calls with
dialstring *1234, the leading * is stripped and replaced
with a trailing 0 (i.e., 12340) causing call to fail.
Resolved IPY00006654 36085 84 Global Call Using Dialogic
®
Global Call SS7 protocol, when ISUP
sent SUSPEND and RESUME message, the Global
Call library did not generate a
GCEV_RETRIEVECALL event.
Resolved IPY00007242 28807 -- Global Call on IP Applications using Dialogic
®
Global Call over IP
cannot switch from voice to T.38 fax after receiving
CNG/CED tone. The remote side can initiate a switch
from voice to T.38 by either sending a RequestMode
for H.323 or a ReInvite for SIP. Currently, Global Call
does not support the sending of RequestMode or
ReInvite.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description