User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 314
Dialogic Corporation
Resolved IPY00010226 36092 74 Host Admin In the DCM Trunk Configuration tab for Dialogic
®
DM/V-B Boards, the Media Load and Trunk protocol
values listed in the pull-down menu at the bottom do
not show the currently selected value at the top when
each is highlighted.
Resolved IPY00009466 32615 18 Host Admin Only administrators should have write access to the
RTF config file.
Resolved IPY00009426 32539 56 Host Admin When performing a “Restore Device Defaults,” the
service startup mode gets reset to automatic, which
can cause problems with customers expecting the
state to remain at Semi-Automatic or Manual.
Resolved IPY00009305 34805 56 Host Admin If you reboot the system without stopping the
Dialogic
®
System Service, an error occurs when trying
to start the system again.
Resolved IPY00009263 33385 56 Host Admin When a Dialogic
®
DM/V-A or DM/V-B Board is shut
down in DCM, an error event is generated in the
Windows
®
Event Viewer. The error message is
“dwCheckPoint=6”. The error event can be ignored,
since boards can be restarted without error and
applications can be run without a problem.
Resolved IPY00008881 33156 18 Host Admin In certain systems, the transmit timeslot information is
not correctly assigned for a few devices on a board.
For example, dx_getxmitslot( ) will return -1 on
certain devices, or the output from devmapdump will
not show the correct transmit timeslot information for
certain devices, while other devices on the same
board will have correct transmit timeslot information.
There is a high probability that this problem occurs on
the first few devices on a board.
Resolved IPY00008308 32313 62 Host Admin NCM_GetVersionInfo( ) reports incorrect version
information. This occurs when getting “About”
information in DCM as well as when retrieving the
information through the API.
Resolved IPY00008243 35013 56 Host Admin Using dt_xmitwink( ) toggles abcd bits from 0000-
>1111 instead of 0000->1010 as in previous releases.
Resolved IPY00007997 31583 30 Host Admin When starting and stopping services, DCMOBJ.EXE
memory usage and handle count increase continually
and never get deallocated. This also happens when
using the NCM API and polling to see if services have
started up.
Resolved IPY00007715 32343 25 Host Admin In systems with Dialogic
®
Springware Boards only, a
dialog box with an error message is displayed when
accessing any option under Settings->System/Device
Autostart of DCM. The error message states “Failed to
set Device Autostart setting”, and “Requested data not
found in NCM data storage.”
Resolved IPY00007352 31530 18 Host Admin Uninstall cleanup utility does not report whether it
passed or failed.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description