User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 318
Dialogic Corporation
Resolved IPY00010556 35157 56 Host Library Calling ATDV_SUBDEVS( ) on Dialogic
®
DM3 MSI
stations while alarms are being processed on DM3
trunks on span cards can cause a deadlock condition
in the application, which can hang the system for 8
seconds.
Resolved IPY00009758 32759 63 Host Library Calls to unsupported or unimplemented functions on
Dialogic
®
DI/0408-LS-A Boards are resulting in an
incorrect error code being generated.
Resolved IPY00009004 32303 18 Host Library An application may see a deadlock while using
Streaming to Board. For Streaming to Board, an
application calls dx_PutStreamData( ) to put data in
the Circular Stream Buffer. As a result of issuing this
API, if the total size of the data in the Circular Stream
Buffer happens to cross the high water mark set by the
application, a process deadlock may occur between
the application thread calling the
dx_PutStreamData( ) and an internal thread in the
library.
Resolved IPY00008151 33070 18 Host Library Problems occur with rtf logging; enabling modules in
'RtfConfigWin.xml' does not log any information to the
rtflog.log file.
Resolved IPY00007995 32188 30 Host Library Any ODI error in the rtflog.txt file that has an error
code of 0x2801e can be ignored, since this is not a
functional error. This error only indicates that the
queried Dialogic
®
DM3 component does not exist.
This is an expected error if the component being
queried does not exist in the firmware due to the pcd
file downloaded.
Resolved IPY00037004 -- 142 IP IP trunks hang due to missing gc_AnswerCall( )
event.
Resolved IPY00032664 -- 105 IP RFC2833 DTMFs not detected by Dialogic
®
DM/IP241
Boards.
Resolved IPY00011037 36677 98 IP Host Inbound fax call fails. This happen when previous call
on the same device is dropped and media devices are
disconnected using gc_SetUserInfo( ).
Resolved IPY00034413 -- 134 IP Media Session
Control (RTP)
Parameter checking behaves inconsistently when
calling ipm_StartMedia( ).
Resolved IPY00035506 -- 131 ISDN An ISDN call disconnects during the ACCEPT state.
When this occurs the application does not get a
CCEV_DISCONNECT event.
Resolved IPY00030001 36796 118 ISDN ISDN traces not functional for NI2 and QSIG on
Dialogic
®
DM3 Boards.
Resolved IPY00016178 28372 -- ISDN Dialogic
®
DM3 ISDN firmware formats all outbound
messages with the Interface ID bit set to 1. This has
resulted in both incoming and outgoing calls being
rejected.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description