User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 323
Dialogic Corporation
Resolved IPY00010372 35035 56 Protocols After sending CAS_HOOKFLASH, there should be
some delay before sending DTMF in
pdk_sw_e1_necls_io protocol, if
CDP_WaitDialToneEnabled = 0 (i.e., do not wait for
dialtone).
Resolved IPY00010223 34985 56 Protocols pdk_sw_e1_ermx_io.cdp can only accept one ringing
signal (the internal ringing or the external ringing but
not both). Defining CAS_RING_APPLIED (0001 ->
0xxx) solves the detection of the two ringing signals
but causes problems with outgoing calls.
Resolved IPY00010004 34685 56 Protocols When using the pdk_us_mf_io protocol in the Feature
Group D configuration, the protocol does not send a
Disconnect signal when it times out waiting for DNIS
and ANI. This occurs when the remote side is
configured as Feature Group B and makes a call.
Resolved IPY00009943 34160 62 Protocols If pdk logs are enabled for TxRx bit information (by
adding “ALL INTEGER_t
PSL_TXRX_LOG_ENABLE=1” in the respective .cdp
file), gc_MakeCall( ) fails with GCEV_TASKFAIL.
Resolved IPY00009887 34053 25 Protocols When configuring a system to use ISDN NI2 protocol
in conjunction with NT1, the D-channel does not come
up.
Resolved IPY00009837 35049 56 Protocols There seems to be a hard-coded 30-second timeout
on a Make Call when the call is made in Alerting
mode, which will terminate the call if no one picks up
the phone. The expected behavior is that the call will
not be dropped automatically, so the phone will ring
forever if no one picks up. This occurs on T1 CAS
lines.
Resolved IPY00009409 34663 56 Protocols When using FXS protocol and calling a busy station
using supervised transfer, you get a disconnect event
for both the consultation CRN and transferred CRN.
Resolved IPY00009407 32547 18 Protocols The gc_SetChanState( ) function fails to return a
completion event or error indication when using the
pdk_us_mf_io protocol on a Dialogic
®
DM/V960A-4T1
Board.
Resolved IPY00009272 33981 27 Protocols When using Qsig protocol, a DISCONNECT message
is received 4 seconds of making a call into a cellular
network. The cause code is 102 “Recovery on timer
expiry”.
Resolved IPY00008963 32443 18 Protocols A GCEV_MEDIADETECTED event is not generated
when running FXS on a Dialogic
®
DM/V960A-4T1
Board and the call is not answered until after the
CA_ANSWER time-out.
Resolved IPY00008634 31778 18 Protocols cc_CallAck( ) sends incorrect IEs when used for
sending a host controlled PROCEEDING message.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description