User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 325
Dialogic Corporation
Resolved IPY00006748 34587 56 Protocols The PDK E1 CAS protocol cannot be downloaded on
Dialogic
®
DM3 Boards, and Dialogic
®
Springware
Board channels cannot be opened when using this
protocol.
Resolved IPY00006735 34344 56 Protocols On Dialogic
®
DM3 Boards, when dialtone is enabled
on Belgium R2 protocol, if the first DTMF/MF digit of
DNIS sent is 1 then the DNIS digits received at the
inbound side are not the same as sent by the
outbound side.
Resolved IPY00039179 -- 162 PSTN Call Control During a glare scenario, a GCEV_RELEASECALL
event is incorrectly returned to the synchronous
function gc_ReleaseCall( ). Events should only be
returned from asynchronous functions.
Resolved IPY00038979 -- 160 PSTN Call Control The pdk_sw_e1_fxs_io protocol does not forward the
correct reason when a call is disconnected due to
detection of a SIT. The reason should indicate that SIT
was detected.
Resolved IPY00038612 -- 160 PSTN Call Control When calling gc_BlindTransfer( ) synchronously, the
function sometimes returns -1 and takes
approximately 30 seconds to return with this error.
Resolved IPY00038494 -- 160 PSTN Call Control CP failure on Dialogic
®
DM/N960-4T1 Board.
Resolved IPY00038244 -- 154 PSTN Call Control If gc_MakeCall( ) is called with GC_PARM_BLK set to
NULL, ERR1 is shown in the RTF log.
Resolved IPY00038130 -- 154 PSTN Call Control A GCEV_FATALERROR occurs on Dialogic
®
D/480JCT-2T1 Board.
Resolved IPY00037607 -- 148 PSTN Call Control If another call comes in between a gc_DropCall( )
and gc_ReleaseCallEx( ), the call is not detected.
The problem occurs when the drop call and release
call are issued within 1-2 seconds of each other.
Resolved IPY00036886 -- 142 PSTN Call Control The call type information is incorrectly being
encapsulated in the METAEVENT's extevtdatap
pointer in the GCEV_OFFERED event when using
ISDN call control on Dialogic
®
DM3 Boards.
Resolved IPY00036833 -- 142 PSTN Call Control When using NI2 protocol on Dialogic
®
JCT Boards,
disconnect glare causes next call to be rejected with
cause code 44, channel not available.
Resolved IPY00036830 -- 142 PSTN Call Control The DPNSS cause “Network Termination” (NT=0x02)
is not supported.
Resolved IPY00036448 -- 142 PSTN Call Control With 5ESS ISDN on Dialogic
®
Springware Boards, call
setup fails when the CALLED NUMBER TYPE is set
to NETWORK_SPECIFIC (0x03).
Resolved IPY00036347 -- 142 PSTN Call Control QERROR_WARNING messages appear in
Dm3StdErr log. Eventually, gc_SetChanState( ) fails
on all channels, and all channels are blocked.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description