User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 326
Dialogic Corporation
Resolved IPY00036337 -- 139 PSTN Call Control 5ESS for Dialogic
®
DM3 Boards did not support
CALLED NUMBER TYPE in the
NETWORK_SPECIFIC (0x03), IE.
Resolved IPY00036248 -- 139 PSTN Call Control When using Dialogic
®
Global Call SS7, the 0xb and
0xc address signals, which were previously reported
to the application as “b” and “c”, are now getting
reported as “#” and “*”, thus breaking backward
compatibility.
Resolved IPY00036247 -- 139 PSTN Call Control A Dialogic
®
JCT Board running with the NT1 protocol
receives an Alerting message with incorrect
GCEV_PROCEEDING event instead of the expected
GCEV_ALERTING on a channel.
Resolved IPY00036101 -- 139 PSTN Call Control User program cannot obtain a large UUI information
along with other IEs using cc_GetSigInfo( ) on
Dialogic
®
JCT Boards.
Resolved IPY00036044 -- 139 PSTN Call Control Failures seen when invoking gc_SetChanState( ) on
Dialogic
®
JCT Boards.
Resolved IPY00035451 -- 131 PSTN Call Control WinXP gc_OpenEx( ) fails for device “:N_dkB1T1” for
Dialogic
®
SS7 Board when configured for clear
channel.
Resolved IPY00035148 -- 131 PSTN Call Control The gc_Unlisten( ) function has no effect when
issued on “dk” devices using Dialogic
®
Global Call
SS7.
Resolved IPY00034816 -- 131 PSTN Call Control SIT tone not detected on Nortel Meridian protocol.
Resolved IPY00034738 -- 131 PSTN Call Control Call progress analysis does not properly report fax
tone when parameter All INTEGER_t
CDP_OUT_ConnectType has a value of “1”.
Resolved IPY00034618 -- 125 PSTN Call Control gc_DropCall( ) fails when responding to a
GCEV_DISCONNECT event after a
GCEV_BLOCKED event.
Resolved IPY00034606 -- 131 PSTN Call Control While issuing a make call during a supervised transfer
to a destination that is busy, gc_ResultMsg( ) returns
with PROTOCOL ERROR.
Resolved IPY00034050 36636 116 PSTN Call Control SIT tone operator intercept is incorrectly reported as
Unknown SIT tone to the application on Dialogic
®
DMV160LP Board.
Resolved IPY00034018 -- 115 PSTN Call Control SIT tone operator intercept is incorrectly reported as
Unknown SIT tone to the application on Dialogic
®
DMV960A and DMV160LP Boards.
Resolved IPY00033698 -- 124 PSTN Call Control The primary call cannot be re-transferred via
gc_SetupTransfer( ) when the transferred call is
disconnected after SwapHold.
Resolved IPY00033244 -- 113 PSTN Call Control Dialogic
®
DM/V1200BTEP Board is sending a
RELEASE COMPLETE (with cause 0x22) after
receiving a CALL PROCEEDING.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description