User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 328
Dialogic Corporation
Resolved IPY00035831 -- 134 SIP Call Control Segmentation fault occurs in libipm_vsc.so when
calling gc_close( ) on Dialogic
®
Global Call (IP based)
line device.
Resolved IPY00035822 -- 134 SIP Call Control Dialogic
®
Global Call SIP application does not
respond to 407 Proxy Authentication Required
messages.
Resolved IPY00035613 -- 134 SIP Call Control Fails to send a BYE message after dropping call on
Avaya IP PBX.
Resolved IPY00032715 -- 110 SIP Call Control SIP 3xx redirection and forward message: cannot set
(or retrieve) more than one redirection address.
Resolved IPY00033102 -- 125 SIP Call Transfer Supervised transfer fails on Party B getting
GCEV_XFER_FAIL.
Resolved IPY00036855 -- 154 SNMP When using MIB2 from RFC1213, Dialogic
®
SNMP
agent fails to return valid information when a “get”
command is issued.
Resolved IPY00010060 34495 56 SNMP SNMP service crashes periodically. The event log
entry reads: “Faulting application snmp.exe, version
5.2.3790.0, faulting module CosNaming405.dll,
version 0.0.0.0, fault address 0x00004e2e”.
Resolved IPY00009266 34050 56 SNMP dlgagent.log under “c:” is created by SNMP and
increases automatically when DCM starts.
Resolved IPY00033492 -- 131 Springware Boards After repeating of network connection down and up
while service/app is running, some channels cannot
re-establish layer 2 connection, send or receive calls.
Resolved IPY00021428 30443 -- Springware Boards The listboards utility will not display the model number,
configuration ID, or the driver state for Dialogic
®
Springware Boards.
Resolved IPY00009171 29859 18 Springware Boards A board configured for Layer 2 access should be able
to bring down/up layer 2 on demand. When cycling a
few times through the UP and DOWN states with the
NE1 firmware on trunk 1 and CTR4 firmware on trunk
2, it eventually becomes impossible to activate layer 2.
Resolved IPY00039427 -- 166 Springware Call
Control
If an outbound call is made (gc_MakeCall( )) and then
a gc_DropCall( ) is issued, a drop call event should
be received. But instead, a disconnect event is
returned.
Resolved IPY00039331 -- 165 Springware Call
Control
When using DPNSS, the response to the setup
message from the switch is incorrect; an incomplete
Number Acknowledge Msg is returned.
Resolved IPY00039249 -- 162 Springware Call
Control
When gc_WaitCall( ) is issued after an incoming call
is pending, the gc_AcceptCall( ) fails even though the
application receives the GCEV_OFFERED event.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description