User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 332
Dialogic Corporation
Resolved IPY00028518 35832 84 Springware
Firmware
GCEV_DROPCALL event is not returned after calling
gc_DropCall( ) if GCEV_DISCONNECT is sent by the
firmware due to time-out.
Resolved IPY00028458 35154 58 Springware
Firmware
Dialogic
®
Springware NI2 firmware sets and sends the
interface ID bit and Octet 3.1 in its setup message
when configured for NFAS circuits.
Resolved IPY00028448 36319 94 Springware
Firmware
Disconnect glare causes the next call to be rejected
with cause code 44, requested channel not available.
Resolved IPY00028415 35011 65 Springware
Firmware
When using DPNSS firmware, disconnection is not
completed properly. A dropcall complete event is not
received after a remote disconnect event, and the
application is left hung in a “disconnecting” state.
Resolved IPY00028313 34814 65 Springware
Firmware
When using an R2 protocol and the user attempts to
make a call with greater than 10 DNIS digits, the
R2MF response buffer contains garbled data.
Resolved IPY00010668 34476 56 Springware
Firmware
DE_RINGS event is not received properly for double
interrupted ring in ROLM 9005 with Dialogic
®
D42JCT-
U Board.
Resolved IPY00010663 34719 56 Springware
Firmware
When DCM is used to set the country code to South
Africa (ZA), no audio (or sometimes half-duplex audio)
is present.
Resolved IPY00010611 34999 56 Springware
Firmware
Dialogic
®
Springware NI2 firmware sends out the
“Interface Identifier” octet (3.1) all the time for the
PROCEEDING message, causing the switch to reject
the call.
Resolved IPY00010475 34241 39 Springware
Firmware
Using DPNSS firmware, when a call is made to a PBX
extension that is on Divert, the application does not
receive a Diversion IE and therefore cannot make a
call to the “diverted to” extension.
Resolved IPY00009981 34345 39 Springware
Firmware
Events seem to block on certain channels when using
CSP firmware.
Resolved IPY00009068 34788 56 Springware
Firmware
Dialogic
®
D82 Board ports cannot be made VMS port
from PBXDRVR.
Resolved IPY00009008 32192 18 Springware
Firmware
Disconnect glare causes the next call to be refused
with cause code 44 - requested channel not available.
Disconnect glare is caused when the user side hangs
up; but before the switch recognizes this disconnect, it
sends its own disconnect. The next incoming call
should be accepted, but in some cases it is being
rejected, with the ISDN firmware responding that the
channel is not available.
Resolved IPY00008640 32704 18 Springware
Firmware
There are caller ID issues (with single and multiple
hop forwarded calls) when using the Nortel Norstar
PBX.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description