User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 334
Dialogic Corporation
Resolved IPY00036949 -- 139 Springware ISDN
Firmware
With Service Update 108 and later, outbound ISDN
calls are rejected by the switch due to missing IE
(octet 3.1, Extension Bit/Interface Identifier). In
Service Update 108, Dialogic
®
Springware firmware
was changed to stop sending octet 3.1 if a board was
not configured in an NFAS group. However, if a switch
requires octet 3.1 to be present in the setup message
for non-NFAS configurations, the call is now rejected.
If the switch requires octet 3.1 to be present for non-
NFAS configurations, perform the following:
Step 1. Modify the nfas.cfg file so that each span is in
its own NFAS group.
#NFAS group 1
# Board ID Interface ID D-Channel board ID NFAS group ID
1 0 1 1
2 1 2 2
3 2 3 3
Step 2. Do not modify parameter 0016 in the PRM file
for each span as you normally would within an NFAS
environment. Instead, leave the D-channel as
enabled:
;---
;--- ENABLE/DISABLE the D channel (Parameter type 16H)
;--- Used only when the protocol type (Parameter number 13H) is
PRI ISDN
;--- for NFAS configuration.
;--- Possible values for the data are as follows:
;--- 00H = Undefined.
;--- 01H = Enable the D channel.
;--- 02H = Disable the D channel.
0016 01
Resolved IPY00007547 29780 -- Springware JCT Dialogic
®
D/41JCT and VFX/41JCT Boards do not set
correct RING status bit after first boot up.
Resolved IPY00036665 -- 160 Springware
Network
When using DPNSS firmware, disconnection is not
completed properly. A dropcall complete event is not
received after a remote disconnect event, and
spurious interrupt firmware crashes occur.
Resolved IPY00039490 -- 174 Springware PBX The d42_setparm( ) for the parameter 0x1A does not
work on the Dialogic
®
D/42JCT-U Board.
Resolved IPY00038206 -- 155 Springware PBX Using d42_chnstatus( ) causes a memory leak.
Resolved IPY00030570 35921 84 Springware PBX Outbound calls made from the PBX are dialing extra
digits at random times.
Resolved IPY00028459 36329 90 Springware PBX Display is parsed incorrectly while attempting to view
ACD statistics when calling d42_display( ) or
d42_displayex( ) when using Nortel_Meridian_1.fwl.
Resolved IPY00010787 36134 90 Springware PBX When a Dialogic
®
D/82JCT-U Board is connected to a
Siemens Hicom, it consistently loses and re-gains
carrier on multiple ports.
Resolved IPY00009297 34095 84 Springware PBX d42_displayex( ) doesn't return the correct softkey
displays for Mitel SX-200 PBX.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description