User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 346
Dialogic Corporation
parameters are now applicable to these boards. For information about this feature,
including configuration information, see Section 1.45, “IP Support on Dialogic
®
DI0408LSAR2 Boards”, on page 152 and Section 1.46, “Dialogic
®
DI0408LSAR2
Board Support for Host Systems with Multiple NICs”, on page 159 of this Release
Update.
Update for adjusting DTMF characteristics
Because of a new feature in the Service Update, you can now adjust DTMF parameter
values, such as amplitudes and on/off durations, in the Tone Templates [tonegen]
section of a particular media load CONFIG file. For information about this feature, see
Section 1.49, “Adjusting DTMF Characteristics through the CONFIG File”, on page
174 of this Release Update.
Update to Media Load 11 on page 22 (PTR# 33555/34771)
Media Load 11 description on page 22 should read:
Media Load 11 - Enhanced Voice Plus Conferencing (Dialogic
®
DM/IP241-1T1-PCI-100BT and
DM/IP301-1E1-PCI-100BT Boards only)
• All Enhanced Voice features (see Media Load 2)
• Conferencing resource
Update to Table 1 on page 23 (PTR# 33555/34771)
Table 1 on page 23 should be modified as follows:
• The last two board entries, Dialogic
®
DM/IP481-2T1-PCI-100BT and DM/IP601-
2E1-PCI-100BT, should be ignored.
• The note at the bottom of the table associated with the ‡ symbol should read:
Media load 11 only applies to Dialogic
®
DM/IP single-span boards.
Parameters not applicable to this release
The following parameters, which are documented in the guide, are not applicable in
Dialogic
®
System Release 6.0 PCI for Windows
®
:
• Derive NETREF Two From
• NETREF Two Clock Rate
• NETREF Two FRU
• Using NETREF Two
Update to Section 2.4, Media Loads for new media loads
Because of features introduced in the Service Update, several new media loads are
available:
• for Dialogic
®
DMV3600BP Boards: ML9B-LC
• for Dialogic
®
DMV1200BTEP Boards: QSB-U3, QSB-ML10, QSB-ML10-LC,
QSB-U2, and 10b.
• for Dialogic
®
DMV600BTEP Boards: DSB-U2
These media loads should be documented in Section 2.4, Media Loads. For
information about these media loads, see Section 1.68, “New Media Load for
Dialogic
®
DMV3600BP Boards”, on page 242, Section 1.69, “New Media Loads for
Dialogic
®
DMV1200BTEP Boards”, on page 244, and Section 1.70, “New Media Load
for Dialogic
®
DMV600BTEP Boards”, on page 247 of this Release Update.