User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 355
Dialogic Corporation
Digital Signaling
Description: Allows you to designate E1 time slot 16 for signaling or to choose clear-channel
signaling.
Values:
• TS16_SIG [default]: Designates time slot 16 to be used for signaling.
• TS16_CLEAR: Selects clear-channel signaling.
Guidelines: To use this parameter, you must also set a value for the Country parameter. Consult
the Country Parameter Selection Table in the DCM online help to verify that the value you
choose for this parameter can be used for the country selected.
3.2.3 Dialogic
®
GDK 5.0 Installation and Configuration Guide for
Windows
®
In addition to the updates described in this section, refer to the separate document
Updates for GDK Version 6.0 and Dialogic
®
System Release 6.0 PCI for Windows
®
for
other updates applicable to the Dialogic
®
GDK 5.0 Installation and Configuration Guide for
Windows
®
. Also, for additional information about configuring Dialogic
®
CPI/2400PCIU-T1
Boards, refer to the tech note at this link (PTR# 33698, 33699):
http://www.dialogic.com/support/helpweb/dxall/tnotes/legacy/2000/tn091.htm
Do not use the procedure in Section 3.3.4 of the Dialogic
®
GDK Version 5.0 Installation
and Configuration Guide for Windows
®
for configuring the NETREF One FRU parameter.
Instead, follow the procedure titled “Setting the TDM Bus Clock Source” in Section 4.5
of the Dialogic
®
DM3 Architecture PCI Products on Windows
®
Configuration Guide
(PTR# 24782).
3.2.4 Dialogic
®
Global Call Country Dependent Parameters (CDP)
for PDK Protocols Configuration Guide
New CDP_In_ANIBeforeDNIS parameter
Because of a new feature in the Service Update, a new parameter,
CDP_In_ANIBeforeDNIS, has been added to the CDP files for all countries/protocols
that use the pdk_r2_io protocol module. This parameter specifies the order of DNIS,
ANI, and Category digits. For further information about the new parameter, see
Section 1.55, “New Parameter for Order of DNIS and ANI”, on page 222 of this
Release Update.
Update to Section 2.4.2, Downloading the Protocol and CDP File on a Windows
®
System
Because of a new feature in the Service Update, it is no longer necessary to set up
the pdk.cfg file manually and run pdkmanagerregsetup to download the protocol and
CDP file. Instead, a new PDK Configuration property sheet in DCM is used to assign
country dependent parameter (CDP) file variants to trunks that use CAS or R2MF
protocols, and the pdk.cfg file is generated automatically. The need to run
pdkmanagerregsetup has been eliminated. For further information about this feature,