User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 356
Dialogic Corporation
see Section 1.35.1, “PDK Configuration Property Sheet”, on page 105 of this Release
Update.
The following note should be added after the first paragraph of this section
(PTR# 36373):
Note: If the automatically generated pdk.cfg file is deleted and not present in the
%INTEL_DIALOGIC_CFG% directory, then all subsequent attempts to start
the Dialogic
®
services will fail with no discernible error.
Update to Chapter 43, North American Analog Bidirectional Protocol Parameter
Configuration
Because of a new feature in the Service Update, there are additional parameters in
the pdk_na_an_io.cdp file to support analog call transfer. For further information
about this feature, see Section 1.3, “Analog Call Transfer Support on Dialogic
®
Springware Boards”, on page 38 of this Release Update.
3.2.5 Dialogic
®
System Release 6.0 PCI for Windows
®
Software
Installation Guide
There are currently no updates to this document.
3.3 OA&M Documentation
This section contains updates to the following documents (click the title to jump to the
corresponding section):
• Dialogic
®
Board Management API Library Reference
• Dialogic
®
Configuration Manager (DCM) Online Help
• Dialogic
®
System Software Diagnostics Guide
• Dialogic
®
System Software for PCI Products on Windows
®
Administration Guide
• Dialogic
®
Native Configuration Manager API Library Reference
• Dialogic
®
SNMP Agent Software for Windows
®
Administration Guide
3.3.1 Dialogic
®
Board Management API Library Reference
Update to brd_Open( ) function
Because of a new feature in the Service Update for firmware assert notification on
Dialogic
®
JCT Boards, the brd_Open( ) function has a new mode parameter,
BRD_FW_ASSERT_ENABLE. There is also a new event, DMEV_FW_ASSERT. For
information about this feature, see Section 1.50.3, “Firmware Assert Notification”, on
page 181 of this Release Update.
Update to brd_SendAliveEnable( ) function
The description of the brd_SendAliveEnable( ) function currently says: