User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 357
Dialogic Corporation
The network interface is taken out of service by providing the network with a protocol-specific out-
of-service condition.
Because of a new feature in the Service Update, the network interface is taken out-of-
service by sending an Alarm Indication Signal (AIS) toward the network rather than a
protocol-specific out-of-service condition. For information about this feature, see
Section 1.74, “Extended Board Management API Support for Dialogic
®
DM3 Boards”,
on page 258 of this Release Update.
3.3.2 Dialogic
®
Configuration Manager (DCM) Online Help
Parameters that are not applicable
The following parameters, which are documented in the DCM online help, are not
applicable in Dialogic
®
System Release 6.0 PCI for Windows
®
:
• Derive NETREF Two From
• NETREF Two Clock Rate
• NETREF Two FRU
• Provide NETREF Two
• Provide NETREF Two From
• Using NETREF Two
• Frequency Resolution
New parameters for Dialogic
®
DI0408LSAR2 Boards
Because of a new feature in the Service Update for IP support on Dialogic
®
DI0408LSAR2 Boards, two parameters have been added to DCM: DI_TOS and
HostIpMediaNetworkAddress. For information about these parameters, see
Section 1.45, “IP Support on Dialogic
®
DI0408LSAR2 Boards”, on page 152 and
Section 1.46, “Dialogic
®
DI0408LSAR2 Board Support for Host Systems with Multiple
NICs”, on page 159 of this Release Update.
New parameters for stand-alone configuration
Because of a new feature in the Service Update for stand-alone configuration
(applicable to selected Dialogic
®
JCT Boards), two parameters have been added to
DCM: NFASPrimary and Using Cable Mode. For information about these
parameters, see Section 1.50.2, “Stand-Alone Configuration”, on page 180 of this
Release Update.
Update to CSPExtraTimeSlot help topic (IPY00041018)
The following note for using the CSPExtraTimeSlot parameter is incorrect:
• If you enable CSP for a board, do not enable that board’s EC_Resource parameter.
The note should be changed to:
• If you enable CSP for a Dialogic
®
Springware Board, you must also enable that board’s
EC_Resource parameter.
Update to Derive Primary Clock From (User Defined) help topic
The help topic for Derive Primary Clock From (User Defined) should read as
follows:
Description: This parameter specifies the clock source that the Primary Master FRU uses to drive
the Primary Line.