User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 358
Dialogic Corporation
Update to Digital Signaling parameter help topic
The information in the help topic for the Digital Signaling parameter should read as
follows:
Description: Allows you to designate E1 time slot 16 for signaling or to choose clear-channel
signaling.
Value s:
• TS16_SIG [default] Designates E1 time slot 16 to be used for signaling.
• TS16_CLEAR Selects clear-channel signaling.
Note: To use this parameter, you must also set a value for the Country parameter. Consult the
Country Parameter Selection Table in the DCM online help to verify that the value you choose for
this parameter can be used for the country selected.
Update to DisconnectTone parameter help topic
In the help topic for the DisconnectTone parameter, the Applicability field in the
Rules section should read:
All Dialogic
®
Springware Voice Boards and Dialogic
®
DMV160LP Boards.
In the help topic for the DisconnectTone parameter, the Description field should
read:
Enables or disables support of Disconnect Tone Supervision. Disconnect Tone Supervision allows
voice processing boards to sense a disconnect has occurred at the PBX by listening for the PBX
disconnect tone.
In the help topic for the DisconnectTone parameter, the following note is added to the
Settings field:
Note: For Dialogic
®
DMV160LP Boards, this parameter must also be enabled in the CONFIG file
associated with the board. For information about enabling Disconnect Tone Supervision using the
Tone_SigID4 parameter in the CONFIG file, see the [CHP] Analog Voice Variant Definitions
section of the CONFIG File Parameter Reference chapter in the Dialogic
®
DM3 Architecture PCI
Products on Windows
®
Configuration Guide.
Settings Value Explanation
Default The value of this parameter is to be determined by the system software.
Its current value is indicated by the Resolved Equivalent.
FrontEnd_1 The Primary Master derives clocking from its own front end network
interface. This value only applies when the TDM Bus Type (Resolved) is
set to SCbus and the Primary Master FRU (Resolved) is a Dialogic
®
Springware Board.
FrontEnd_2 The Primary Master derives clocking from its own second network
interface. This value only applies when the TDM Bus Type (Resolved) is
set to SCbus and the Primary Master FRU (Resolved) is a Springware
Board.
FrontEnd_3 Not supported
FrontEnd_4 Not supported
InternalOscillator The Primary Master derives clocking from its own circuitry.
NETREF_1 The Primary Master derives clocking from NETREF_1 (CT Bus only).
NETREF_2 Not supported