User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 381
Dialogic Corporation
Update to GCEV_EXTENSION
Because of a new feature in the Service Update, a new event has been added,
EXTENSIONEVT_RAWEEM. For further information about the new feature, see
Section 1.33, “New Fax Parameter for Modem Receive Level”, on page 99 of this
Release Update.
3.4.11 Dialogic
®
Global Call API Programming Guide
Figure 27 and Figure 28 have incorrect titles and appear in the wrong order and position
(PTR# 32481):
The existing Figure 28 should have the caption “Call State Model for Supervised and
Unsupervised Transfers” and should appear in Section 3.6.4.2, “Supervised
Transfers” immediately before the existing Figure 27. The paragraph immediately
before the figure should read:
The call state transitions that occur during a supervised transfer are shown in Figure 27 (which
also shows the call state transitions for an unsupervised transfer).
The existing Figure 27 should have the caption “Call Termination by the Network or
Application During a Transfer” and now becomes the new Figure 28. The paragraph
immediately before the figure should read:
If the network or application terminates a call during a transfer, call state transitions are as
shown in Figure 28.
Finally, in Section 3.6.4.3, “Unsupervised Transfers” the last paragraph should read:
Figure 27 illustrates the call state transitions that occur in an unsupervised transfer, which
basically includes only:
• The transition of Call 1 from the Connected to the Idle state (invoked by the
gc_BlindTransfer( ) function)
• The transition of Call 1 from the Idle to the Null state (invoked by the
gc_ReleaseCallEx( ) function)
Update to Section 7.2.3, Configuring Call Progress Analysis on a Per Call Basis
Because of a new feature in the Service Update, new custom special information
tones (SITs) are allowed and are reported to the application via the
GCEV_DISCONNECTED event once any one of them is detected via Dialogic
®
Global Call Software. For further information about this feature, see Section 1.8,
“Enhanced Special Information Tones on Dialogic
®
DM3 Boards Using Voice and
Global Call APIs”, on page 55 of this Release Update.
Update to Section 7.2.4, Setting Call Analysis Attributes on a Per Call Basis
(IPY00006588 = PTR# 36210)
This section (page 121) provides incorrect information regarding the
CCPARM_CA_PVD_QTEMP parameter. The correct information is as follows:
CCPARM_CA_PVD_QTEMP
PVD Qualification Template. Specifies which PVD template to use. Possible values are:
• PAMD_QUAL1TMP – Predefined qualification template. This is the default value.
• -1 – No qualification template
The CCPARM_CA_PVD_QTEMP parameter can also be set to a qualification template ID
that is defined in the CONFIG file.
Setting CCPARM_CA_PVD_QTEMP to a value of PAMD_QUAL2TMP is not supported.