User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 382
Dialogic Corporation
CCPARM_CA_PAMD_QTEMP
PAMD Qualification Template. Specifies which PAMD template to use. Possible values are:
• PAMD_QUAL1TMP – Predefined qualification template. This is the default value.
• -1 – No qualification template
The CCPARM_CA_PAMD_QTEMP parameter can also be set to a qualification template ID
that is defined in the CONFIG file.
Setting CCPARM_CA_PAMD_QTEMP to a value of PAMD_QUAL2TMP is not supported.
Note: The default qualification templates are no longer suitable for accurate PVD and PAMD on
Dialogic
®
DM3 Boards and should be modified in accordance with the instructions in Technical
Note 030 available on the Customer Support web site at
http://www.dialogic.com/support/helpweb/dxall/tnotes/legacy/2000/tn030.htm. The technical note
is written specifically for Dialogic
®
System Release 5.1.1 for Windows
®
Feature Pack 1, but the
principle applies to subsequent releases also.
Update to Chapter 12, Debugging
In addition to the various Dialogic
®
Global Call Technology Guides that are referenced
here for technology-specific debugging information, this chapter should also mention
the Runtime Trace Facility (RTF) logging tool. For information about the RTF tool, see
Section 1.41, “Enhancements to Runtime Trace Facility (RTF) Logging”, on page 113
of this Release Update.
3.4.12 Dialogic
®
Global Call Analog Technology Guide
Update for gc_GetANI( ) (PTR# 33202)
Section 3.7, gc_GetANI( ), should include the following note:
Note: The gc_GetANI( ) function is deprecated in this software release. The suggested equivalent is
gc_GetCallInfo( ).
Updates for gc_MakeCall( ) (PTR# 32379)
When using the PDK analog protocol, gc_MakeCall( ) returns the GCEV_TASKFAIL
event when no dial tone is detected. This should be added to Table 9, Analog Call
Conditions and Results, in the “Event/Return Value” column for the “No dial tone
detected” condition. This should also be added to Section 2.5, Call Progress and
Call Analysis, in the paragraph about gc_MakeCall( ) as follows:
The gc_MakeCall( ) function defines the maximum time (in seconds) within which a call must be
answered. Within that interval, busy and ringback tones can be detected. Dialogic
®
Global Call
Software will disconnect an outbound call and report a GCEV_CALLSTATUS,
GCEV_DISCONNECTED, or GCEV_TASKFAIL event to the application if the call is not
answered within the default time-outs defined by the protocol or the gc_MakeCall( ) function.
Update for loop current reversal detection on Dialogic
®
DMV160LP Board
Because of a new feature in the Service Update, loop current reversal detection is
now supported on the Dialogic
®
DMV160LP Board. The Dialogic
®
Global Call Analog
Technology Guide does not currently include any information about how to implement
this. For information about this feature, see Section 1.48, “Loop Current Reversal
Detection on Dialogic
®
DMV160LP Boards”, on page 170 of this Release Update.
Update for analog call transfer support on Dialogic
®
Springware Boards
Because of a new feature in the Service Update, blind and supervised analog call
transfers are now supported for Dialogic
®
Springware Boards. The Dialogic
®
Global