User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 71
Dialogic Corporation
When configuring the system for the PCI Express form factor boards, use the same menu
selections and configuration settings that are documented for the PCI version of the
boards. Any differences are discussed below.
Note: When installing the Dialogic
®
DMV300BTEPEQ, DMV600BTEPEQ, and
DMV1200BTEPEQ Boards, be sure to refer to the Installation Guide (Dialogic
®
Quick
Install Card) that is provided with each board for important information about power
budgeting and guidelines for selecting the slot where a board can be installed.
Features
The Dialogic
®
DMV300BTEPEQ, DMV600BTEPEQ, and DMV1200BTEPEQ Boards
support the same features as the existing Dialogic
®
DM/V-B PCI Boards plus new media
loads, lower latencies/increased performance, and first time support for a single span
Dialogic
®
DM3 board.
Some of the features for these boards are listed below. Refer to the product data sheet,
which is accessible at http://www.dialogic.com/products, for additional information about
applications, configurations, features, and technical specifications.
• Software selectable T1/E1. Ability to mix T1 and E1 on each network interface.
• Ability to combine protocols on the same board. Protocols within a group can be
mixed among network interfaces on the same board; however, protocols from different
groups cannot be mixed on the same board.
• Group 1: Mix any combination of 4ESS (T1), 5ESS (T1), NTT (T1), NI2 (T1), DMS
(T1), QSIGT1 (T1), QSIGE1 (E1), NET5 (E1), T1CC (T1 Clear Channel), CAS
(T1), E1CC (E1 Clear Channel), R2MF (E1) protocols on the same board.
• Group 2: Mix any combination of DPNSS (E1) or DASS2 (E1) protocols on the
same board.
• Ability to send alarm state to the network at all times from power-up to application
start-up (i.e., trunk preconditioning).
• Universal load available (simultaneous voice + speech + fax + conferencing) on all
Dialogic
®
DM/V-B Boards. All supported media loads are listed below.
• A-Law/Mu-Law conversion.
Note: Fixed routing configuration is not supported on Dialogic
®
DM/V-B Boards. Refer to the
Dialogic
®
DM3 Architecture PCI Products on Windows
®
Configuration Guide for more
information about configuration, media loads, and mixing of protocols for the above
features and board support.
Media Loads
The media loads supported by the Dialogic
®
DMV300BTEPEQ, DMV600BTEPEQ, and
DMV1200BTEPEQ Boards are listed below.