User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 79
Dialogic Corporation
values are provided that are consistent with previous service updates and system
releases to preserve backward compatibility.
Pre-Record Beep Tone Characteristics and Default Values
Two pre-record beep tones are defined:
• A custom customer tone, BEEP_DGSD, defined as 444 Hz for 400 ms, and
BEEP_DLGC, defined as 1000 Hz for 400 ms.
• The traditional pre-record beep tone, BEEP_DLGC, defined as 1000 Hz. This
corresponds to the beep tone definition on Springware Boards and is the default
setting.
The [recorder] section of the CONFIG file includes the following parameter, which
specifies the tone to be used in the application:
BeepSignalID (Pre-Record Beep Tone)
Number: 0x203
Description: The BeepSignalID parameter is the signal identifier of the beep tone
preceding the recording.
Values:
• 0x21: 444 Hz tone for 400 ms
• 0x22: 1000 Hz tone for 400 ms (default)
The pre-record beep tone characteristics for the two beep tones, stored in the Tone
Templates [tonegen] section of the CONFIG file, are described as follows:
Record Beep Tone Characteristic Default Value
BEEP_DGSD Signal Id 33
Label (blank)
Segment Count 1
Segment Signal Type 2
Segment Frequency 1 (Hz) 444
Segment Amplitude 1 (.25 dbm) -40
Segment Frequency 2 (Hz) 0
Segment Amplitude 2 (.25 dbm) 0
Segment On Duration (125 microsecs) 3200
Segment Off Duration (125 microsecs) 320
Segment Reps 1
Next Segment 65535