User Manual
Chapter 6 Configuring Ports for Terminals and Computers 27
Configuring Ports for Terminals: Web Interface
Use this procedure to configure a port from the web interface.
1. Access the web interface by entering the device server IP address in a
browser’s URL window.
2. Log on to the device server as root. The default password is dbps.
3. From the main menu, choose Configure > Ports.
4. Choose the port from the port column.
5. Ensure that the Device type is set to Terminal.
6. Make changes to the configuration as required. Use the online help for
information.
7. If you want to apply this configuration to multiple ports, choose Clone,
select the ports for this configuration, and then choose Continue.
8. Choose Submit.
9. To return to the main Ports menu, choose Ports from the Menu again.
Commands for Configuring Ports for Terminals
• set ports
• set line
• set flow
Port Defaults
• VT-100 emulation
• 9600 baud
• 8-bit characters
• 1 stop bit
• No parity
• Software flow control
Related Information
• For information on the set line, set ports, and set flow commands,
see the Digi One/PortServer TS Command Reference.
• For information on configuring terminal ports for autoconnections,
see, "Configuring Autoconnection" on page 35.
Note: The set line settings must match the settings of the attached terminal or
Chapter 6
Configuring Ports for
Terminals and Computers