User Manual

62 Chapter 15 Configuring Console Management
device for RADIUS authentication, see the chapter on Configuring
RADIUS. See the following section on how to configure SSH for
authentication.
If you want to use SSH2 connections and use an SSH public key for
authentication, do the following:
• enter the following command
set user name=name loadkey=host:key
where
• name is the name of a user
• host is either an IP address or DNS name of a host running TFTP
• key is the name of a file that contains the DSA public key. If your
host’s implementation requires a complete path to the file, specify
the path here as well.
Example:
set user name=secure loadkey=143.191.2.34:ssh-file
Note: Use the table to determine whether your Digi product supports SSH2 connec-
tions using a public key for authentication.
Device Firmware Version
PortServer TS 8 82000684c or higher
PortServer TS 16