User Manual

68 Chapter 15 Configuring Console Management
4. Choose Submit to save your configuration.
Configuring Console Groups
To assign groups to the power units, do the following:
1. From the menu, choose Configure > Power > and the Outlet you are
configuring. The Outlet is listed in the Plugged Into column.
2. A configuration screen appears. In the Console Group field select a
group from the pull down menu to assign the group to the Outlet. The
Device Name and Plugged Into fields are already filled by the configura-
tion utility.
3. In the Power Management Users section, check the boxes to assign
control either by the device name, the console group, or both. If none
are selected, users assigned to this device may only manage this
device, rather than a group of devices.
The Power Management options become accessible only when a Con-
sole Group or Device Name have been assigned.
Choose Submit to save your configuration.
For additional console settings, see set powerunit in the Digi One/
PortServer TS Command Reference.
Configuring Device Names
1. From the menu, choose Configure > Power > and the Outlet you are
configuring. The Outlet is selected from the Plugged Into column.
2. Enter the name you want to assign to control the Outlet in the Device
Name field.
If information is already present in the field, highlight the field and enter
the new information.
3. In the Power Management Users section, check the boxes to assign
control either by the device name, the
console group, or both.
If none are selected, users assigned to this device may only manage
this device, rather than a group of devices.