User Manual
Chapter 17 Troubleshooting 83
RealPort
• Specify
set ports dev=rp to define a device type.
• Configure serial line attributes on the RealPort host.
• Configure flow control on the RealPort host.
Printer
• For most printers, specify
set ports dev=prn
• Use the set line command to configure serial line attributes that are
consistent with peripheral requirements.
• Use the set flow command to configure flow control attributes that
are consistent with peripheral requirements.
Incoming Modem
• For most incoming modem connections, specify
set ports dev=min
• Use the set line command to configure serial line attributes that are
consistent with peripheral requirements.
• Use the set flow command to configure flow control attributes that
are consistent with peripheral requirements.
Outgoing Modem
• For most outgoing modem connections, specify
set ports dev=mout
• Use the set line command to configure serial line attributes that are
consistent with peripheral requirements.
• Use the set flow command to configure flow control attributes that
are consistent with peripheral requirements.
Two-way Modem
• For both incoming and outgoing modem connections, specify
set ports dev=mio
• Use the set line command to configure serial line attributes that are
consistent with peripheral requirements.
• Use the set flow command to configure flow control attributes that
are consistent with peripheral requirements.
Terminal
• For most terminal connections, specify
set ports dev=term
Also, if you have configured the port for autoconnection, ensure that
the destination IP address and TCP port (dport) are correct.
• Use the set line command to configure serial line attributes that are
consistent with peripheral requirements.