Specifications

36 DC-530 Operation Manual
5.9 Sample, Count and Print a Label
NOTE: For this function to be used on the DC-530, an external printer must be connected to the scale. For more information on
how to connect an external printer, see
Section 7.1.
1. Press the REZERO key to zero the scale.
2. Place the empty bin on the scale and press the TARE key.
3. Place a 10 piece sample of the item in the bin and press the PCS key. (For maximum accuracy, count
the 10 piece sample into your hand and then add the entire sample to the bin at one time, instead of
adding them one or two at a time.) If 10 pieces are not enough for the scale to get an accurate sample, the
scale will prompt you to add a specific additional number of pieces. Add these pieces and press the
PCS
key again.
4. Add the remaining pieces to be counted into the bin.
5. Press the * PRINT key. The scale will print a label in the default label format.
Figure 5-3. Weight Label Without Entering or Recalling an Item Code
5.10 Scan ID Bar Code, Count and Print a Label
NOTE: For this function to be used on the DC-530, an external printer and a barcode scanner must be connected to the scale.
For more information on how to connect an external printer, see
Section 7.1 . For information on connecting a barcode scanner,
see Section 7.5.
1. Enter the ID Code by scanning the ID Bar Code.
1. Press the REZERO key to zero the scale.
2. Place the container of the product on the scale platter.
3. Press the * PRINT key. The scale will print a label in the default label format.
Figure 5-4. Weight Label with Item Code