User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Displays
5-7
6700-A2-GY31-70
July 1999
H Zoom Out
Choose Zoom Out from the Action pull-down menu to return to the previously
displayed view. Each time you choose the Zoom Out command, the
displayed view comes from the last in, first out buffer. See the Zoom In
command. This command is inactive (gray) if the zoom in buffer is empty or
the Geographic Map window is not the active window.
H Select Default View
Choose Select Default View from the Action pull-down menu to assign the
default view. The default view displays when the Geographic Map window
opens and is listed in the View menu with an asterisk next to it. Follow the
procedure below.
" Procedure
1. Choose Select Default View from the Action pull-down menu. A Selection
Default View dialog box appears.
2. Select one of the user-defined views listed.
3. Choose OK.