User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Displays
5-19
6700-A2-GY31-70
July 1999
Control
Select Control from the Carrier Monitor menu bar to access the Control window.
The Control pull-down menu appears listing the commands Make Busy, Remove
Busy, Connect to Service Line, and Disconnect from Service Line. The
Commands menu items are inactive (gray) unless one or more devices are
selected.
Make Busy
Choose Make Busy from the Control pull-down menu to change the device
configuration to Busied Out. The selected device(s) configuration icon
changes to Busied Out. If any selected device is Busied Out, this command is
inactive (gray).
Remove Busy
Choose Remove Busy from the Control pull-down menu to change the
device’s Busied Out configuration. The selected device(s) configuration icon
returns to its normal state. If any selected device is not Busied Out, this
command is inactive (gray).
Connect to Service Line
Choose Connect to Service Line from the Control pull-down menu to connect
the selected device to the service line. This command is inactive (gray)
unless the single device selected is not connected to the service line. The
following are several suggestions for when to use the service line:
— When the normal lines fail.
— When the device does not have a dedicated dial line.
— To permit dialing into a specific device connected to a rotary (sequencer).
Normally, if a device is connected to a rotary, direct dial-in access is not
guaranteed since the rotary gives the call to the next available device.
Disconnect from Service Line
Choose Disconnect from Service Line from the Control pull-down menu to
disconnect the selected device from the service line. This command is
inactive (gray) unless the single device selected is connected to the service
line.
Commands
Select Commands from the Carrier Monitor menu bar to access commands to
manage devices, access an information dialog box, list operation status codes
used in the Device Activity boxes, and display a connectivity diagram.
Device Management (DevMgt)
Select DevMgt from the Commands menu to access the Device Management
window. This menu is inactive (gray) unless a device(s) is selected. All
selected device(s) appear in the device selection list. See Chapter 7,
Device
Management
, for additional information.