User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-2
6700-A2-GY31-70
July 1999
Selecting Devices
All Statistics windows have one common requirement:
H One or more devices must be selected prior to collecting any statistical data.
" Procedure
1. Choose Selection from the current Statistics window menu bar. The Selection
pull-down menu appears.
2. Choose Device Selection from the Selection pull-down menu to display the
Device Selection dialog box.
3. If all the devices listed are correct, go to Step 7.
4. If all the desired device(s) are not listed, choose Devices to access the
Selection Browser and create a new list of devices. See
Device Selection
in
Appendix A,
NMS Windows Conventions
, for additional information on using
the Selection Browser.
– or –
If a list of devices has been saved, the Use Saved Selections button is
enabled. Choose Use Saved Selections to recall your previously saved list.
5. To remove any device(s) from the list, choose Devices to access the device
selection and remove devices from the list.
6. To save the current list of devices, select Save Selections before choosing
OK. The saved list can only be recalled by the same user from within the
same window.
7. Choose OK. All the devices in the device selection list are used by the
current window.