User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-4
6700-A2-GY31-70
July 1999
The second section is the currently displayed chart or data display. See
Setting
Up the System Printer
in Chapter 4,
Configuration
, for additional information on
printer selection.
Dial Utilization Snapshot
The Dial Utilization Snapshot command allows you to monitor and display how
selected devices are being used (Idle, Connected, Busied Out, or in Test) at a
single point in time (snapshot). Use this command to display the percentage of
devices in each of the four modes. The percentages are displayed in pie chart
format, upgraded at a user-defined rate (snapshot frequency).
Choose Dial Utilization Snapshot from the Statistics pull-down menu to display
the Dial Utilization Snapshot window. Displayed in the menu bar are Selection
and Commands.