User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-9
6700-A2-GY31-70
July 1999
2. Select the time interval from the times displayed in the list box.
3. Select the Save Selection check box to make the current snapshot
frequency the default. The new interval is used each time the Connect Time
Utilization Monitor bar chart displays. A unique snapshot frequency can be
saved by each user for the Connect Time Utilization Monitor window. If the
Save Selection check box is not selected, the snapshot frequency is used
until the Connect Time Utilization Monitor window is closed and then the
default snapshot frequency is restored.
4. Choose OK.
Commands
Use the Commands pull-down menu on the Connect Time Utilization Monitor
menu bar to access commands to collect, pause, and print Connect Time
statistics; and to access the Device Management and Device Information
windows.
Collect
Use Collect on the Commands pull-down menu to start or continue the chart
updating process. Collect is inactive (gray) unless one or more devices are
selected. When you choose Collect, the following occurs:
— The chart is updated.
— Print and Pause become active.
— Collect becomes inactive.
— The information displayed in the window is updated at an interval equal to
the snapshot frequency.
Pause
Use Pause on the Commands pull-down menu to stop the chart updating
process. When you choose Pause, the following occurs:
— The chart update process is suspended.
— Collect becomes active.
— Pause becomes inactive (gray).
Device Management (DevMgt)
Use DevMgt on the Commands pull-down menu to access the Device
Management window. This command is inactive (gray) unless a device list is
selected. See Chapter 7,
Device Management
, for additional information.
To access the Device Management window, either double-click on one of the
devices listed in the window or select DevMgt from the Commands pull-down
menu. All the devices listed in the current window are passed to the Device
Management window’s device selection list. The highlighted Device Name is
the one acted upon first by Device Management.
Accessing Device Management from the Commands pull-down menu does
not close any of the Statistics windows.