User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-16
6700-A2-GY31-70
July 1999
After the device(s), period and intervals have been selected, choose Execute to
display the Call Duration Distribution chart. The chart indicates the number of
calls placed during the selected reporting period, for up to ten user-defined
intervals. The list below the chart displays daily average call duration, the
standard deviation, the total number of calls, the reporting period, and the days of
the week used for the chart.
Selection
Use Selection to designate the devices to be included in the chart, change the
chart title, change the report period, or change the intervals monitored. Select
Selection from the Call Duration Distribution menu bar to display the Selection
pull-down menu listing the commands Device Selection, User Defined Title,
Select Report Period, and Distribution Periods.
Device Selection
Use Device Selection to select one or more devices to be represented in the
Call Duration Distribution chart. See
Selecting Devices
on page 6-2 for
additional information. All devices in the device selection list are used for the
Call Duration Distribution chart.
User Defined Title
Use User Defined Title to change the title of the Call Duration Distribution
chart. See
User Defined Titles
on page 6-3 for additional information on
changing the title.
Select Report Period
Use Select Report Period to specify or change the days included in the chart.
Follow the procedure below.