User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-17
6700-A2-GY31-70
July 1999
" Procedure
1. Choose Select Report Period from the Selection pull-down menu. The Select
Report Period dialog box appears.
2. Select the start date by using the scrolling Start Date field to set each part of
the date (month, date, year). The current date is the default start date. See
Date Field
in Appendix A,
NMS Windows Conventions
, for additional
information on scrolling date fields.
3. Select the end date by using the scrolling End Date field to set each part of
the date (month, date, year). The current date is the default end date.
4. From within the Days to Include list box, select which days to include in the
chart. The days of the week not included in the data range are inactive (gray).
The default day is the current day of the week.
5. Choose OK.
H Distribution Periods
Use Distribution Periods to specify or change the periods included in the
chart. Follow the procedure below.
" Procedure
1. Select Distribution Periods from the Selection pull-down menu. The
Distribution Periods dialog box appears. The ten periods display with the
current value shown in drop-down list boxes.