User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-20
6700-A2-GY31-70
July 1999
The display lists the selected device(s), sorted by the designated field. The
possible fields, depending on the device selected, are as follows:
Local Device Name: The name of the local device associated with the call.
Remote Device Name: The name of the remote device associated with the
call. The information contained in this field is device dependent and is not
available from all devices.
Connect Time: The date and time the call was initiated.
Duration: The length of the call in hours, minutes and seconds.
Line Speed: The baud rate used during the call.
Disconnect Reason: The message reported by the device indicating the
reason the call disconnected or failed. Valid entries are as follows:
— Busy Signal: The remote device was busy.
— DTR Disconnect: The device disconnected because the DTR dropped.
— EC Disconnect: The device disconnected because of the failure to
negotiate the EC mode or because the EC link failed.
— Invalid Number: The device was unable to dial because the number was
wrong.
— Ln Currnt Disc: The device disconnected due to loss of the line current.
— Long Space Disc: The device disconnected because a long space was
detected.
— None: Normal local or remote disconnect.
— No Answer Tone: The remote device did not answer.
— No Carrier Disconnect: The device disconnected because the carrier
was not present.
— No Data Disc: The device disconnected because no data was detected.
— No Dial-DTR: The device was unable to dial because DTR was off.
— No Dial Tone: The device aborted because there was no dial tone.
— No Prompt Tone: No prompt tone, such as a credit card proceed tone,
was received.
— Rmt Cmnded Disc: The device disconnected due to V.32 Cleardown or
Error Control (EC) disconnect received from the remote end.
— Trunk Busy: The device received a Trunk Busy signal.