User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Statistics
6-22
6700-A2-GY31-70
July 1999
H User Defined Title
Use User Defined Title to change the title of the Call Statistics Detail Display
data listing. See
User Defined Titles
on page 6-3 for additional information
on changing the title.
H Select Report Period
Use Select Report Period to specify or change the days included in the data
listing. Follow the procedure below.
" Procedure
1. Choose Select Report Period from the Selection pull-down menu. The Select
Report Period dialog box appears.
2. Select the start date by using the scrolling Start Date field to set each part of
the date (month, date, year). The current date is the default start date. See
Date Field
in Appendix A,
NMS Windows Conventions
, for additional
information on scrolling date fields.
3. Select the end date by using the scrolling End Date field to set each part of
the date (month, date, year). The current date is the default end date.
4. From within the Days to Include list box, select which days to include in the
data listing. The days of the week not included in the data range are inactive
(gray). The default day is the current day of the week.
5. Choose OK.
H Select Sort Key
Use Select Sort Key to specify or change which field the data display is
sorted on. Follow the procedure below.
" Procedure
1. Choose Select Sort Key from the Selection pull-down menu. The Select Sort
Key dialog box appears listing the six available sort fields.