User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Device Management
7-13
6700-A2-GY31-70
July 1999
The following is an example of a completed Remote Loopback test with Pattern
(BERT) selected. If Pattern was not selected, choose the Abort button or the
Abort command from the Test pull-down Window menu to halt the test.
Pattern (BERT)
Choose Pattern (BERT) from the Test pull-down menu to cause the selected
device to transmit a bit error rate test (BERT) pattern and monitor for errors. A
remote device must be connected and transmitting the BERT pattern. Choose
Pattern (BERT) and the Pattern window appears.
Pattern Window for Analog Type Devices