User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Device Management
7-19
6700-A2-GY31-70
July 1999
Abort All Tests
Choose the Abort All Tests command from the Test pull-down menu to abort any
test running on the selected device, as well as all tests running on downstream
devices. This command aborts any test regardless of how the test was initiated.
Commands
Use the Commands pull-down menu to access commands for identifying, testing,
and controlling devices. The commands on this menu vary, depending on the
selected device. Possible commands include ID, CallSetup, Connectivity,
Disable, Enable, External Leads, Reset Device, Local Telephone, Report
Terminal Power, Send Message, Standby Facility, ISDN Telephone Numbers,
Service Profile ID’s, Reset Device, Reset Call Counter, and Print. Each of
these commands is detailed in the following sections.
Device Identification
Choose ID from the Commands pull-down menu to display the Device
Identification window. Use this window to view information obtained from the
device.
Except for the Execute button, the window is blank until the information is
obtained from the device. Choose Execute to start the function. During the period
of time the information is transferring from the device, Execute changes to
Abort. Choose Abort to stop the process.
When the information is received, it appears in the Device Identification window
and Abort changes back to Execute.