User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Device Management
7-23
6700-A2-GY31-70
July 1999
Standby Facility
Choose Standby Facility from the Commands pull-down menu to establish or
disconnect the Dial Backup facility for a DSU device. When the Standby Facility
dialog box is displayed, choose either Originate to request a DSU DBM device to
establish a DDD backup facility or Release to request a DSU DBM device to
disconnect a DDD backup facility.
ISDN Telephone Numbers
Choose ISDN Telephone Numbers from the Commands pull-down menu to
display and update the local telephone numbers assigned to an ISDN DBM
configuration. When you choose ISDN Telephone Numbers, the Local ISDN
Telephone window appears.
Choose Display to read the local ISDN telephone numbers from the device.
Enter up to two local ISDN telephone numbers in one of the following ways:
Type the desired number in either the First Phone # or Second Phone #
field. Valid characters are 0–9, *, #, ^, %, +, -, |, a, space, comma, ;, (, ), p,
P, t, T, w, W. Do not exceed 36 characters per telephone number.
Use the Phone Book to select a number from the Network Phone Book. See
Chapter 4,
Configuration
, for more information about the Phone Book. The
first number selected will be placed in the First Phone # field. You can also
click on the desired field name first, either First Phone # or Second Phone #,
and then click on a telephone number in the Phone Book list.
Choose Update to send the telephone numbers to the device.