User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Device Management
7-25
6700-A2-GY31-70
July 1999
Print
Choose Print from the Commands menu to print the current Device Management
window and all windows opened from it. See
Setting Up the System Printer
in
Chapter 4,
Configuration
, for additional information on using printers.
Window
Choose Window from the Device Management menu to change how the Device
Management windows appear or to close all the open Device Management
windows. Choosing Window causes a drop-down menu to display listing the
commands Tile, Cascade, Arrange Icon, and Close All.
The Window commands only affect the windows or icons opened from the same
Device Management window. If two or more Device Management windows are
open, the Window commands only operate on the windows opened from the
current Device Management window.
The windows opened from the current Device Management window are listed
below the last command. A check mark indicates the active window. To change
the active window, select the window name from the list.
Tile
Choose Tile from the pull-down menu to have the windows arranged in a
side-by-side manner. This allows viewing of several windows simultaneously
(side-by-side) with the disadvantage that each window is smaller than if they were
displayed on top of each other. The following example shows three Device
Management windows displayed in the tile fashion.