User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
8-1
6700-A2-GY31-70
July 1999
Dial Function
8
Dial Function Overview
This chapter describes how to use the Dial function to connect a local device to a
remote device. This function is also available through the CallSetup command
on the Commands pull-down menu from the Device Management menu bar.
When you use Call Setup through Device Management, you have already
selected a local device. If you choose Dial from the Commands pull-down menu
or via the Dial icon in the toolbar, you must first select a local device.
The following example shows the Dial window for 2400 Series, 3800 Series and
3900 Series analog-type devices.