User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Firmware Download
9-2
6700-A2-GY31-70
July 1999
3. To select the device(s) for the firmware download, use the Devices button to
access the Selection Browser and create a new list. Only devices of the
same model type of the selected firmware revision appear in the device list
box. See
Device Selection
in Appendix A,
NMS Windows Conventions
, for
additional information on using the Selection Browser.
All devices displayed within the Device list box will be downloaded.
4. If a device does not qualify for downloading, the Unavailable Download
Devices dialog box appears, showing all unavailable devices to be purged
from the list.
Once you have made the appropriate device selections, click on the
Download button. The ADp Firmware Download window appears.
The ADp firmware download process can last up to four hours. You can iconify
the ADp Firmware Download window, and it will blink when the download is
finished. The download can be aborted in progress by using the Cancel button.
However, if you cancel a download before the process completes, all device(s)
use the firmware version installed prior to the download attempt.
The fields on the ADp Firmware Download window are:
Download Information: Contains data about the current download: Type of
Download, Model, Firmware Level, and Checksum.
Download Status: Contains status information about the current download.