User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Reports
10-7
6700-A2-GY31-70
July 1999
Configuration
Use Configuration to create a report listing the current NMS configuration
records. The three basic types of configurations are Contacts, Devices, and
Device Groups.
Contacts
Use the Contacts command to generate a report of all the network contacts
configured in NMS. See
Configuring Network Elements
in Chapter 4,
Configuration
.
Procedure
1. Select Configuration from the Reports pull-down menu. The Device
Configuration Report window appears.
2. Select Type from the Device Configuration Report menu bar. The Type
pull-down menu appears.
3. Choose Contacts from the Type pull-down menu. The Contact Configuration
Report window appears. This window is identical to the Device Configuration
window except for the title bar.
4. Select the report destination, either to the monitor or the printer.
— If the report is to be sent directly to the printer, select Printer in the
Destination box.
— If the report is to be sent directly to the monitor, select Display in the
Destination box.
— Choose Execute.
See
Generating a Report
on page 10-2 for additional information.