User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Reports
10-12
6700-A2-GY31-70
July 1999
The fields for the site section of the Device Configuration Report are described as
follows.
H Site Name: The name of the site.
H Contact Names: The name of the persons to contact at the site.
H Comments: Any comments entered during configuration.
Device Groups
Use the Device Groups command to generate a report of all the device groups
configured in NMS. See
Configuring Network Elements
in Chapter 4,
Configuration
.
" Procedure
1. Select Configuration from the Reports pull-down menu. The Device
Configuration Report window appears.
2. Select Type from the Device Configuration Report menu bar. The Type
pull-down menu appears.
3. Choose Device Groups from the Type pull-down menu. The Contact
Configuration Report window appears. This window is identical to the Device
Configuration window except for the title bar.
4. Select the report destination (monitor or printer).
— If the report is to be sent directly to the printer, select Printer in the
Destination box.
— If the report is to be sent directly to the monitor, select Display in the
Destination box.
5. Choose Execute.
See
Generating a Report
on page 10-2 for additional information.