User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Reports
10-16
6700-A2-GY31-70
July 1999
The fields for the Network Hierarchy Report are as follows:
H Site Name: The site’s name where the device is installed/located.
H Cabinet Name: The cabinet’s name where the device is installed.
H Carrier Name: The carrier’s name where the device is installed.
H Device Name: The device’s name.
H Serial Number: The device’s serial number.
H Model: The device’s model number.
Alert Control Report
Use Alert Control Report to create a report listing all the current alert priorities
and duration filters configured in NMS. See
Configuring Network Alerts and
Events
in Chapter 4,
Configuration
, for additional information.
" Procedure
1. Select Alert Control from the Reports pull-down menu. The Alert Control
Report window appears.
2. Select the report destination (monitor or printer).
— If the report is to be sent directly to the printer, select Printer in the
Destination box.
— If the report is to be sent directly to the monitor, select Display in the
Destination box.
3. Choose Execute.
See
Generating a Report
on page 10-2 for additional information.