User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Session
11-4
6700-A2-GY31-70
July 1999
Delayed Shutdown
The Delayed Shutdown commands enables a Multiuser feature server to select
a delay for system shutdown.
NOTE:
This command is active only for COMSPHERE 6700 Series NMS Multiuser
feature servers.
Procedure
1. Choose Delayed Shutdown from the Session pull-down menu. The Delayed
Shutdown dialog box appears.
2. Select the desired delay using the scrolling range field (1–60 minutes).
3. Choose OK. The Multiuser feature clients will then be notified of the delayed
shutdown.