User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Data Input Sheets
D-6
6700-A2-GY31-70July 1999
ALERT CONTROLS – MODEL CONFIGURATION DATA INPUT SHEET
Device Model:
Alert Priority Duration Exclude Alert
Device Failure:
Configuration Change Notify:
Test Mode:
Disabled:
VF Threshold Exceeded:
Facility Alarm:
External Alarm:
Streaming Terminal:
TDM Failure:
Dial Backup Active for APL:
DTE Alarm:
Sub-normal Operating Speed:
Primary Channel Interrupted:
Firmware Downloading:
Make Busy Mode:
Service Line:
Non-answering Modem:
Short Holding Time Modem:
No Response:
Alert Priority is either Critical, Major, or Minor.
Duration is between 5 and 300 seconds in 5 second increments.
Exclude Alert is either N for don’t exclude or Y for exclude.