User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-5
6700-A2-GY31-70
July 1999
Configuring Network Elements
To configure network elements for the NMS database, select Config from the
Main Menu and then choose Network. Complete the configuration data input
forms to add data to the network database.
Use the Action commands (Table 4-1) to save, change, delete, clear, or print
configuration information or to change the name of the network element.
Configuring a Contact List
A contact list is a user-defined directory of all primary and secondary contact
names, addresses and telephone numbers in the network.
Contact List commands allow you to create, change, delete, or print contact
configuration information. To create or change contact information, complete the
Contact List Configuration input form by completing the appropriate fields. Use
the commands from the Action menu (Table 4-1) to complete configuration.
NOTE:
To change an existing contact name in the contact list without changing the
supporting information, use the Change Name command from the Action
menu. Changing the contact name without using the Change Name
command creates a new contact list record if the entry is a new name, or it
changes the supporting information of an existing contact name.
Procedure
1. Select Config from the Main Menu.
2. Choose Network from the Config menu.
3. Choose Contact Lists from the Network cascading menu. The Contact List
Configuration input form appears.