User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-7
6700-A2-GY31-70
July 1999
Procedure
1. Select Config from the Main Menu.
2. Choose Network from the Config menu.
3. Choose Sites from the Network cascading menu. The Site Configuration
input form appears.
4. Enter the following information in the fields on the Site Configuration input
form by either:
— Using the selection list button to the right of the field to access existing
field entries, or
— Typing the information in the field, then pressing Tab.
Site Name: A required field that designates the geographic location of the
network device(s) (maximum 15 characters). The site name must be unique
to all other network element names in the network.
Example: Lakeland DPC
Comments: Additional site information (maximum 40 characters).
Primary Contact: The name of the person to contact at this site (maximum
25 characters). If a new Primary Contact name is entered, NMS prompts
inquiring if the new name may be added to the NMS database.
Secondary Contact: The name of the person to contact if you cannot reach
the primary contact (maximum 25 characters). If a new Secondary Contact
name is entered, NMS prompts inquiring if the new name may be added to
the NMS database.
5. Either choose Save from the Action menu (see Table 4-1) or go to Step 6 to
save and place the site on the Network Map.
6. Choose Save and Place from the Action menu to place the site on the
Network Map.