User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-8
6700-A2-GY31-70
July 1999
A dialog box appears asking for the following map placement information.
Country: Use the selection list button to select the site’s country.
Telephone: Enter the telephone number, including the area code, if the site
is in the United States or Canada (maximum 20 characters). Enter the city
code if the site is not in the United States or Canada.
7. Choose OK to place the site on the Network Map.
Configuring a Cabinet at a Network Site
Cabinet Configuration commands allow you to create, change, delete, or print
cabinet configuration information used to specify a device’s location.
Procedure
1. Select Config from the Main Menu.
2. Choose Network from the Config menu.
3. Choose Cabinets from the Network cascading menu. The Cabinet
Configuration input form appears.