User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-28
6700-A2-GY31-70
July 1999
Setting Change Configuration Notification
The Configuration Notification command allows you to create an alert anytime
a user modifies a device from the front panel. Also use this command to disable
this feature.
Procedure
1. Select Config from the Main Menu.
2. Choose Network from the Config menu.
3. Choose Devices from the Network cascading menu.
4. Choose Configuration Notification from the Devices cascading menu. The
Device Configuration Notification input form appears.
5. Select a device from the Selected Devices list box, or press the Device
Names button to access the Selection Browser. Refer to
Device Selection
in
Appendix A,
NMS Windows Conventions
, for additional information on using
the Selection Browser.
6. Choose Enable or Disable, as appropriate.