User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-30
6700-A2-GY31-70
July 1999
Configuring a Facility
Facility Configuration commands allow you to create, change, delete, or print
information used to specify the type of facility on the circuit.
Procedure
1. Select Config from the Main Menu.
2. Choose Network from the Config menu.
3. Choose Facilities from the Network cascading menu. The Facilities
Configuration input form appears.
4. Enter the following information in the fields on the Facilities Configuration
input form.
Facility Name: A required field that must be unique for all other network
element names (maximum 15 characters).
Type of Facility: Designates the type of facility on the circuit. Select DDS,
APL, or Other.
Circuit Name: Identifies the value assigned by the carrier (maximum
25 characters). This information is used in problem resolution.
EndPoints 1 and 2: A label that is unique to the network identifying the
device at the endpoint (maximum 15 characters). Selecting the Endpoint 1 or
Endpoint 2 button gives you access to the Selection Browser. Refer to
Device
Selection
in Appendix A
, NMS Windows Conventions,
for additional
information on using the Selection Browser.
Primary Contact: The name of the person to contact for the device at the
endpoint 1 location or the facility provider (maximum 25 characters).
Secondary Contact: The name of the person to contact for the device at the
endpoint 2 location or the facility provider (maximum 25 characters).
Comments: Additional facility information (maximum 40 characters).
5. Choose Save or one of the other commands from the Action menu (see
Table 4-1).